Jigsaw Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13008
Jlab Export is a leading Jigsaw Manufacturer,and suppliers in India
A corded jigsaw cuts curves, straight lines and cut-outs in board and sheet with a narrow blade that moves up and down. This one runs on 220 V, 50 Hz with a brushless motor. Its variable speed covers 500–3100 strokes per minute over a 1 in stroke, and the base tilts for bevel cuts at 0, 15, 30 and 45 degrees.
Specifications
| Supply | 220 V, 50 Hz |
| Motor | Brushless |
| Speed | Variable, 500–3100 strokes/min |
| Stroke length | 1 in |
| Bevel angles | 0°, 15°, 30° and 45° |
| Blade clamp | Keyless |
| Dust blower | Yes |
| Case | Included |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice in Curved and Bevel Cuts
Carpentry trainees begin with a curve drawn on plywood, clamped so the line overhangs the bench. They follow the line at a steady feed and finish the edge with a File. For a window cut-out, they drill a starting hole in the waste with a bit from the Drill Bit Set, using a Portable Electric Drill. The blade goes in through that hole.
Bevel practice comes next. The base is set to 45 degrees for a mitre and back to 0 for a square cut, which students check with a Square. Teachers show how a slower stroke rate keeps plastic from melting and a metal blade from overheating.
Frequently Asked Questions
What does a brushless motor change?
A brushless motor has no carbon brushes rubbing on a commutator, so there are no brushes to wear out or replace. It also makes less heat and sparking inside the tool, and its speed is set electronically.
Which stroke speed should I use?
Use the high end of the 500–3100 range for fast cuts in softwood and plywood. Slow down for metal, plastics and tight curves, where a fast blade overheats or melts the edge.
How do I cut out an opening in the middle of a board?
Drill a hole in the waste area wider than the blade. Put the blade through it with the base flat on the board, and start the saw before the teeth touch the edge of the hole.
How is a blade changed with the keyless clamp?
Unplug the saw first. Release the clamp by hand, pull out the old blade, push the new one fully home with the teeth facing forward, and let the clamp close. No key is needed.
What does the dust blower do?
It directs air onto the cutting line just in front of the blade, clearing sawdust so the marked line stays visible as you cut.
Other Saws and Cutting Machines
- Cordless Jigsaw (battery model with a top handle)
- Jig Saw Machine (stationary machine with a table)
- Portable Jig Saw Machine
- Hacksaw
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
