Punches Set Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-13000
Jlab Export is a leading Punches Set Manufacturer,and suppliers in India
Twelve punches, graded from 1/16 x 2-3/4 inch up to 1/2 x 6 inch, make up this set. With each size to hand, the punch can match the pin or hole in front of you instead of one that is too big or too small. The punches are rust protected.
Specifications
| Set includes | 12 punches |
| Sizes (inch) | 1/16 x 2-3/4, 5/64, 3/32 x 3-1/2, 1/8 x 4, 5/32 x 4-1/2, 3/16 x 4-1/2, 7/32 x 5, 1/4 x 5-1/2, 5/16 x 6, 3/8 x 6, 7/16 x 6 and 1/2 x 6 |
| Finish | Rust protected |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Exercises in Driving Out Pins
In a fitting or motor vehicle lab, students take apart a pinned assembly, such as a collar held on a shaft by a cross pin. They support the part on the open jaws of the Bench Vice or on a block with a hole under the pin. Then they pick a punch a little smaller than the pin, hold it square and tap the pin out with a Ball Peen Hammer.
On reassembly, a punch pushed through two parts lines up their holes before the pin goes back in. Teachers can also show why a punch must be held square, since a glancing blow can bend a slim punch.
Frequently Asked Questions
How do I choose the right punch for a pin?
Choose a punch only a little smaller than the pin, so it follows the pin through without jamming in the hole. The sizes in this set run from 1/16 to 1/2 inch in twelve steps.
How hard should I strike a small punch?
Use light, square blows with a small ball peen hammer. Thin punches bend or snap if they are struck off line or too hard, so start the pin gently and check that it is moving.
What jobs is a set of punches used for?
Driving out cross pins, roll pins and taper pins from shafts, handles and gears, and lining up holes during assembly. Having twelve sizes means each pin gets a punch that fits it.
How should the set be kept?
The punches are rust protected, but wipe off sweat and coolant after use and keep them in a dry place. Keep them together in size order so the right one is quick to find.
Other Punches, Chisels and Hammers
- Punch & Chisel Set (12 piece set in a holder)
- Punch Tool (centre punch)
- Chisel Set
- Engineering Hammer
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026