• +91-85699-09696

Shaper Machine Manufacturer,Supplier and Exporter in India

Shaper Machine

Product Code : EL-PWI-8837
Jlab Export is a leading Shaper Machine Manufacturer,and suppliers in India

A shaper machines flat faces, steps and grooves in metal with a single-point tool carried on a ram that moves to and fro. This 12 in shaper has a 14 in maximum stroke and a 26 in ram. It runs at four speeds from a 1 HP main motor.

Specifications

Machine size12 in
Maximum stroke14 in
Ram26 in long, 8-1/2 in wide
Table to ram distance1/2 in min., 9 in max.
Tool slide vertical travel5 in max.
Table top12 x 9 in
Table slide24 x 10 in
Cross slide length24 in
Speeds4
Main motor1 HP
Minimum order quantity1 unit
Dispatch timeUsually 14–18 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

How the Shaper Cuts

The tool cuts only on the forward stroke of the ram. On the return, the clapper box lets the tool swing up and slide lightly back over the work instead of digging in. A quick-return mechanism brings the ram back faster than it went forward, so less time is lost. Between strokes the table feeds the work sideways along the cross slide until the whole face is covered.

Workshop Practice on the Shaper

A standard ITI fitter or machinist job is to shape a mild steel block square on all six faces. Trainees mark the size with a Vernier Height Gauge, clamp the block in a machine vice on the table and take roughing and finishing cuts. Each new face is checked against the last one with an Engineers Square.

Later jobs include cutting a step, a V-groove or a keyway to a drawing, with the tool head swivelled for angled cuts. Flatness and parallelism are checked with a Dial Gauge on its magnetic base, and sizes with a Vernier Caliper.

Frequently Asked Questions

What is the clapper box for?
It holds the tool on a hinge so that the tool can lift on the return stroke. Without it, the tool tip would drag back against the work and chip. On the forward stroke the cutting force presses the tool firmly back into its seat.

Why does the ram travel back faster than it cuts?
The shaper cuts only on the forward stroke, so the return is idle time. The quick-return mechanism moves the ram back faster than it moves forward, which shortens each cycle and fits more cuts into the same time.

What size of work can it take?
One pass covers up to the 14 in maximum stroke. The table top is 12 x 9 in. The gap between table and ram runs from 1/2 in to 9 in, and it limits the height of the work and its vice.

How do I choose the speed and stroke?
Use a lower speed for hard steel and long strokes, and a higher one for softer metals such as brass or aluminium and short strokes. Set the stroke a little longer than the work so the tool clears both ends.

Is this a metal shaper or a wood shaper?
It is a metal shaper with a ram that carries a single-point tool. In woodworking, the word shaper often means a spindle moulder, which shapes timber edges with a cutter on a vertical spindle. For that work, see the Spindle Moulder Machine.

Other Metal Workshop Equipment

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us