• +91-85699-09696

Water Immersion Heater Manufacturer,Supplier and Exporter in India

Water Immersion Heater

Product Code : EL-PWI-8832
Jlab Export is a leading Water Immersion Heater Manufacturer,and suppliers in India

A water immersion heater is a heating rod that goes straight into the water it has to warm. This one heats water solutions, water baths and water-jacketed apparatus. Its element is a steel or copper tube 8.2 to 8.5 mm in diameter with nickel plating, held in shape by spacers and supports.

Specifications

Element tubeSteel or copper, nickel plated
Tube diameter8.2–8.5 mm
Element supportsSpacers and supports along the element
Element bendsRecompacted
Control optionsIntegral thermostat or thermocouple
UsesWater baths, water-jacketed apparatus, water solutions
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Heating Practicals for School and College Labs

A simple heating-curve practical starts with water in a container and the heater fully covered. Students read a Thermometer at fixed intervals timed with a Digital Stop Watch, then plot temperature against time. The curve climbs steadily and then levels off at the boiling point, because heat supplied during boiling changes the state of the water, not its temperature.

Teachers can also use the heater to warm an aluminium Water Bath for work that needs gentle heating without a flame, such as warming test tubes of solution. With the thermostat option fitted, students can watch the bath temperature drift a little above and below the set point as the element switches off and on.

Frequently Asked Questions

Can the heater be switched on out of the water?
No. Put the rod in the water first, with the heated part fully covered, and only then switch on. In air the element has nothing to carry its heat away and can burn out. Switch off and let it cool before lifting it out.

Does the heater control the water temperature?
Only when it is ordered with an integral thermostat, which switches the element off and on to hold a set temperature. A thermocouple can be fitted instead for monitoring. A plain heater stays on until it is switched off, so check the water with a thermometer.

Which tube materials can I choose?
The element tube is steel or copper, 8.2 to 8.5 mm in diameter, and both are nickel plated. In your enquiry, give the tube material you want and say if a thermostat or a thermocouple should be fitted.

How do I remove scale from the element?
Unplug the heater and let it cool. Soak the heated part in a mild descaling solution, such as dilute citric acid or vinegar, until the white deposit softens, then rinse it in clean water. Heavy scale slows the flow of heat into the water.

Other Laboratory Heaters

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us