Power Driven Pipe Threading Machine Manufacturer,Supplier and Exporter in India
Product Code : EL-PWI-8817
Jlab Export is a leading Power Driven Pipe Threading Machine Manufacturer,and suppliers in India
A power pipe threading machine grips the pipe in a chuck and turns it under motor power, so the threading dies cut without hand effort. This machine takes pipe from 1/8 in to 2 in (3–50 mm) in its speed chuck. A 1/2 HP reversible single-phase motor drives the spindle at 38 RPM, and a foot switch starts and stops it.
Specifications
| Pipe capacity | 1/8–2 in (3–50 mm) |
| Motor | 1/2 HP universal, reversible, single phase |
| Supply | 115 V, 25–60 Hz |
| Spindle speed | 38 RPM |
| Switch | Heavy duty forward/off/reverse, with integral foot switch |
| Chuck | Speed chuck with replaceable rocker-action jaws |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Practice: Threading GI Pipe by Power
On a plumber or fitter course, trainees cut a length of GI pipe with a Hacksaw and close the speed chuck on it. They thread the end with the motor running forward and plenty of cutting oil, then reverse the motor to back the die off. Comparing the result with a thread cut by hand on the Pipe Threading Tool shows the same thread form with far less effort.
A batch exercise has each trainee thread both ends of several short pipes. The pipes are then joined with sockets and elbows, tightened with a Pipe Wrench and checked for leaks with a Pressure Testing Pump. Teachers use the machine to explain chuck jaws, spindle direction and the thread length to stop at.
Frequently Asked Questions
What pipe sizes can the machine thread?
It takes pipe from 1/8 in to 2 in, which is 3 mm to 50 mm. That covers the small and medium pipe sizes used for water lines in buildings and in most plumber training.
What power supply does it need?
The motor is a 1/2 HP single-phase universal type rated 115 V, 25–60 Hz. Check that your workshop supply matches this rating before the machine is connected.
What is the foot switch for?
The integral foot switch starts and stops the spindle while both hands stay on the pipe and the tools. The main heavy duty switch selects forward, off or reverse.
Why does the spindle turn at only 38 RPM?
Cutting a thread on steel pipe needs a slow speed and plenty of cutting oil. A slow spindle keeps the dies cool and gives the operator time to stop at the right thread length.
How does the speed chuck hold the pipe?
Its rocker-action jaws close on the pipe as the chuck is turned and grip harder under cutting load. The jaws can be replaced when their teeth wear.
Other Pipe Threading Equipment
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
