Pipe Threading Tool Manufacturer,Supplier and Exporter in India
Product Code : EL-PWI-8798
Jlab Export is a leading Pipe Threading Tool Manufacturer,and suppliers in India
This hand pipe threading tool cuts threads on pipe ends with a ratchet action. The die head turns by short strokes of the handle instead of full turns. It has four cast iron die heads fitted with alloy steel dies and a two-piece tubular steel handle. The compact ratchet head works close to walls, and the whole set packs into a blow-moulded carrying case.
Specifications
| Die heads | Four, cast iron, with alloy steel dies |
| Drive | Compact ratchet head for work close to walls |
| Handle | Two-piece tubular steel |
| Packing | Blow-moulded carrying case and display sleeve |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Pipe Threading Practicals for Plumber Trainees
In an ITI plumber course, trainees clamp a length of GI pipe in a Pipe Vice and cut it square with a Hacksaw. They file off the burr and fit the die head for that pipe size. Then they work the ratchet handle to cut the thread, brushing on cutting oil as they go. When the thread reaches the right length, the die head is run back off the pipe.
The threaded ends are wrapped with thread sealant, joined with sockets and elbows and tightened with a Pipe Wrench. The practical ends with a leak test of the small pipeline, using a Pressure Testing Pump to hold the joints under pressure while trainees look for weeping threads.
Frequently Asked Questions
How many pipe sizes can this tool thread?
It comes with four die heads, and each head cuts one pipe size. Fit the head that matches the outside diameter of the pipe, then work the ratchet handle to cut the thread.
Why does a ratchet threader suit work near a wall?
A plain die stock needs room to swing its handles through a full turn. With a ratchet head, the handle moves back and forth through a short arc while the die keeps turning one way. Threads can then be cut on pipe already fixed close to a wall or in a corner.
Should cutting oil be used when threading?
Yes. Brush thread-cutting oil onto the pipe end and the dies before and during the cut. It cools the alloy steel dies, carries the chips away and gives a cleaner thread. Brush the dies clean after use and store them lightly oiled in the case.
How do I start the thread straight?
File the pipe end square and remove the burr. Push the die head onto the pipe with steady pressure for the first few strokes until the dies bite, keeping the handle at right angles to the pipe. Once the thread has started, the dies guide themselves.
How is this tool different from a die stock or a threading machine?
This tool turns its die heads with a ratchet and short strokes. A plain die stock is turned through full turns with its handles. A power threading machine turns the pipe with a motor, so the dies cut without hand effort.
Other Pipe Threading and Fitting Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
