• +91-85699-09696

Pipe Bender Manufacturer,Supplier and Exporter in India

Pipe Bender

Product Code : EL-PWI-8816
Jlab Export is a leading Pipe Bender Manufacturer,and suppliers in India

This pipe bender makes 90-degree bends in pipe from 0.5 to 2 in diameter. The pipe is pressed round a cast iron shoe of matching size, so it takes the curve of the shoe instead of kinking. Six shoes come with the bender, the frame is steel, and the top rollers adjust to set the degree of bend.

Specifications

ConstructionSteel
Bending shoes6, cast iron
Pipe diameter0.5–2 in
Bend90 degrees, set by the adjustable top rollers
Overall size22.62 x 21.26 x 6.3 in (L x W x H)
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Pipe Bending Practicals in the Plumbing Shop

Plumber trainees measure along a length of GI pipe with a Tape Measure and chalk the point where the bend must start. They choose the shoe for the pipe size, bend the pipe to the marked angle and check it against a square or a template. A second exercise bends a pipe to turn a wall corner, then threads both ends with the Pipe Threading Tool so it can be joined into a run.

Teachers can bend one pipe in the correct shoe and one in a shoe a size too large. The class then sees how the wall flattens and the bore narrows when the pipe is not supported all round. Comparing a bent offset with one made from two elbows shows why bends give a smoother flow path.

Frequently Asked Questions

What pipe sizes does it bend?
It takes pipe from 0.5 in to 2 in diameter. Six cast iron shoes cover that span, and each shoe is used only with the pipe size it fits, so the pipe is held round while it bends.

Why does pipe kink, and how is it avoided?
Kinking happens when the inner wall of the bend folds with nothing to support it. Using the shoe that matches the pipe and pulling with a steady, even force keeps the section round.

How is the bend angle set?
The top rollers adjust for the degree of bend, up to the 90-degree bend the bender makes. Bend slightly past the angle you need, because steel pipe springs back a little when the load comes off.

How do I mark where the bend should start?
Measure from the pipe end to the point where the bend must begin and mark it. Line the mark up with the start of the shoe before bending. Make a trial bend on a scrap piece first, since the bend uses up some of the pipe length.

Other Pipe and Tube Benders

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us