• +91-85699-09696

Heavy Duty Bench Vice Manufacturer,Supplier and Exporter in India

Heavy Duty Bench Vice

Product Code : EL-PWI-8827
Jlab Export is a leading Heavy Duty Bench Vice Manufacturer,and suppliers in India

Grey iron castings form the body of this heavy duty mechanics vice. The metal is strong under compression and takes up shock well, so the vice suits medium to heavy work on the fitting or plumbing bench. Its main spindle is fully enclosed to keep dirt off the threads, and the main screw nut and handle are chrome plated.

Specifications

TypeMechanics bench vice
DutyMedium to heavy
BodyGrey iron castings
MachiningTo close tolerances
Main spindleFully enclosed
Main screw nut and handleChrome plated
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Workshop Exercises for Fitter and Plumber Trainees

Fitter trainees hold a mild steel block in the vice and file it flat and square with a Flat File. They then cut it to length with a Hacksaw Frame. Holes drilled in the block are threaded with taps from the Tap & Die Set, Metric Small. The heavy cast body also suits chipping with a hammer and cold chisel.

Plumber trainees use the vice for fittings, brackets and short pieces of pipe. For threading or cutting long round pipe they move to a Pipe Vice. The flat jaws of a bench vice can let a pipe turn or squeeze it out of round.

Frequently Asked Questions

Why is grey cast iron used for the vice body?
Grey iron is strong under compression and damps shock and vibration well, which suits a vice that is loaded while filing and chipping. It is weaker in tension, so avoid heavy hammering on the sliding jaw.

Why is the main spindle enclosed?
Filings, chips and grit falling onto an open screw wear its thread and make the vice stiff to turn. With the spindle fully enclosed, the thread stays clean and the jaw keeps running smoothly.

How is the vice fixed to the bench?
Bolt it through its base to a solid bench, with the fixed jaw just clear of the bench edge so long work can hang down past it. For filing, the top of the jaws is usually set near elbow height.

How do I protect finished work in the jaws?
Fit soft jaw covers of aluminium, copper or fibre over the jaws when holding finished, plated or soft parts. The covers stop the hard jaws from marking the surface.

How should the vice be looked after?
Brush off filings after each session, keep a few drops of oil on the slide and screw, and wipe the chrome-plated handle and nut. Never lengthen the handle with a pipe to gain extra force.

Other Vices and Work Holding Tools

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us