• +91-85699-09696

Oxy-Acetylene Equipment Manufacturer,Supplier and Exporter in India

Oxy-Acetylene Equipment

Product Code : EL-PWI-8822
Jlab Export is a leading Oxy-Acetylene Equipment Manufacturer,and suppliers in India

Oxygen and acetylene burned together give a flame hot enough to melt steel. This equipment puts that flame to work for welding, brazing and flame cutting of metals. Hand-held welding and cutting blowpipes come in two kinds, one for high and one for low acetylene pressure. A blowpipe with a cylindrical barrel fits a cutting machine for guided cuts, and regulators bring the cylinder gas down to working pressure.

Specifications

UseWelding, brazing and flame cutting of metals
Welding blowpipesAcetylene and oxygen, high pressure and low pressure types
Cutting blowpipesAcetylene and oxygen, high pressure and low pressure types
Machine-type blowpipeOxygen/fuel gas, cylindrical barrel
Blowpipe partsShank mixer, swaged detachable tips of various sizes
RegulatorsPressure regulators for gas cylinders
Minimum order quantity10 units
Dispatch timeUsually 4–6 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Flame Practicals for Plumber and Welder Trainees

Trainees first learn to light the blowpipe and turn a smoky acetylene flame into a neutral flame, wearing Gas Welding Goggles with the right shade lens. A plumbing exercise then brazes copper tube into a copper Elbow Fitting with a Brazing Rod. The joint is heated evenly all round until the alloy runs into the gap.

Welder trainees run a fusion weld along mild steel sheet and make a straight flame cut on steel plate with a cutting blowpipe. The same blowpipe and regulator set is also offered for fabrication shops as Oxy-Acetylene Equipment, so a college can equip its plumbing and welding sections alike.

Frequently Asked Questions

How do I set a neutral flame?
Light the acetylene first, then open the oxygen slowly. At first a feathery white zone shows round the inner cone. Keep adding oxygen until that feather just disappears and a sharp, rounded inner cone remains. That neutral flame suits most steel welding and copper brazing.

What does the shank mixer do?
The shank mixer is where the oxygen and the acetylene meet and mix before they reach the tip. Well-mixed gas burns as a steady flame at the nozzle, and the detachable tip screws onto the mixer end.

What is the machine-type cutting blowpipe for?
Its cylindrical barrel lets it be clamped in a cutting machine or guide carriage. The machine moves it along at a steady speed for long straight or circular cuts, while the manual blowpipes are held in the hand.

What do the pressure regulators do?
Each regulator fits on its gas cylinder and lowers the cylinder pressure to a steady working pressure for the blowpipe. Fit the oxygen regulator only to an oxygen cylinder and the acetylene regulator only to an acetylene cylinder.

Is it used in plumbing as well as fabrication?
Yes. In plumbing it is used mostly to braze copper pipe joints and to heat seized fittings. In fabrication the same blowpipes weld steel sheet, and the cutting blowpipes cut steel plate.

Other Gas Welding and Cutting Kits

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us