Centrifugal Pump Manufacturer,Supplier and Exporter in India
Product Code : EL-PWI-8829
Jlab Export is a leading Centrifugal Pump Manufacturer,and suppliers in India
This centrifugal pump lifts water with an impeller spinning inside a volute casing, which throws the water outward and builds up pressure at the outlet. The casing and impeller are cast iron of grade FG 200, the shaft is stainless steel and the impeller is dynamically balanced. Models give 2000 to 55000 LPH at pressures up to 3.5 kg/cm².
Specifications
| Casing and impeller | Cast iron, grade FG 200, shell core moulded |
| Shaft | Stainless steel |
| Impeller | Dynamically balanced |
| Suction lift | Up to 8 m |
| Pressure | Up to 3.5 kg/cm² |
| Discharge | 2000–55000 LPH |
| Pipe size | 25 x 25 mm to 80 x 80 mm |
| Power rating | 0.50–2.00 HP |
| Sealing | Gland packing as standard, mechanical seal on request |
| Design | Back pull-out, replaceable wearing parts |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Pump Practicals in the Plumbing Workshop
Plumber trainees fit the pump to a short suction and delivery line, joining the GI pipework with a Pipe Wrench. They prime it, start it and measure the discharge by running the outlet into a measuring tank and timing the rise with a Stop Watch. Repeating the test with the delivery valve partly closed shows the flow falling as the pressure rises.
A maintenance practical has trainees renew the gland packing and set the gland so it drips slightly while running. Where a course needs full head, discharge and efficiency curves, the Centrifugal Pump Test Rig adds an energy meter for the input power.
Frequently Asked Questions
Why does a centrifugal pump need priming?
An impeller spinning in air cannot draw water up the suction pipe. Fill the casing and suction pipe with water before starting. A foot valve at the bottom of the suction pipe holds that water in between runs.
How high can it lift water from a sump?
Suction lift is up to 8 m. Keep the suction pipe short, airtight and as straight as possible, because every bend and leak cuts the lift the pump can manage.
Which model size should I choose?
Choose by the flow and pressure the job needs. Discharge runs from 2000 LPH to 55000 LPH across the models. Pipe sizes go from 25 x 25 mm to 80 x 80 mm, and power ratings from 0.50 HP to 2.00 HP. Send the flow, lift and pipe size with your enquiry.
What does the back pull-out design mean?
The rotating parts can be drawn out from the back of the casing, so the pump is serviced without disconnecting the suction and delivery pipes. Wearing parts are replaceable, and spares are easy to get.
Should I pick gland packing or a mechanical seal?
Gland packing is standard. It is simple to renew and should drip slightly while running so it stays cool. A mechanical seal, available on request, runs without that drip but is a bigger job to replace when it wears.
Other Pumps and Pump Test Rigs
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
