45 Degree Flaring And Swaging Tool Manufacturer,Supplier and Exporter in India
Product Code : EL-AELE-12904
Jlab Export is a leading 45 Degree Flaring And Swaging Tool Manufacturer,and suppliers in India
Two joint-making jobs are done with this kit. It forms a 45 degree flare on a tube end for a flare nut joint. It also swages a tube end out so that another tube of the same size slides in for brazing. It flares nine sizes from 1/8 in to 3/4 in OD and swages seven. The 8-piece kit has a forged steel slip-on yoke and chrome-plated hardened steel bars.
Specifications
| Flaring sizes | 1/8, 3/16, 1/4, 5/16, 3/8, 7/16, 1/2, 5/8 and 3/4 in OD |
| Swaging sizes | 3/16, 1/4, 5/16, 3/8, 1/2, 5/8 and 3/4 in OD |
| Yoke | Forged steel, slip-on |
| Bars | Chrome-plated hardened steel |
| Pieces | 8 |
| Kit contents | 1 slip-on yoke, 2 flaring bars (9 sizes), 5 swaging adapters (7 sizes) |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Flaring and Swaging Practicals
A flare joint practical starts with a square cut from the Tube Cutter and a clean end from the Reamer. Students slip the flare nut on first, clamp the tube in the bar and turn the yoke cone down to form the flare. The flare is checked for an even, crack-free face before the nut is tightened on its fitting.
For swaging, the yoke screw drives a swaging adapter into the tube end held in the bar, forming a socket. The second tube is pushed in, and the joint is cleaned and brazed with Brazing Rod. Both kinds of joint can then be pressure tested with the Nitrogen Pressure Test Kit, so students see which of their joints hold.
Frequently Asked Questions
What is the difference between flaring and swaging?
Flaring opens the tube end into a 45 degree cone that seats on a flare fitting under a flare nut, so the joint can be taken apart. Swaging expands the end into a socket for another tube of the same size, and that joint is brazed.
Should oil be used on the flare?
A drop of refrigeration oil on the cone while flaring helps it slide and gives a smoother face. A little oil on the back of the flare lets the nut turn without twisting the tube. Keep the oil free of grit, which scratches the seat.
Why must the flare nut go on before flaring?
Once the end is flared, the nut can no longer pass over it. A forgotten nut means cutting the flare off and starting again, which is one of the most common mistakes in a first flaring class.
Can it be used on metric tube?
The flaring bars and swaging adapters are sized in inches. Metric tube should be flared and swaged in tools made for metric sizes. A loose fit in the bar lets the tube slip and gives a lopsided flare.
Other Flaring and Tube Forming Tools
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
