Magnetic Stirrer with Heating System Manufacturer,Supplier and Exporter in India
Product Code : EL-RE-2083
Jlab Export is a leading Magnetic Stirrer with Heating System Manufacturer,and suppliers in India
A magnet turning under the top plate spins a PTFE-coated stirring bar inside the vessel, and a heater warms the plate at the same time. One compact unit can therefore dissolve, mix and heat a solution. The speed regulator is continuously variable and a lamp is fitted on the body. Two capacities are made, for up to 1 litre or 5 litres of liquid.
Specifications
| Stirring | Rotating magnetic field applied from below the vessel |
| Speed control | Continuously variable regulator |
| Heating | Built-in, with temperature control |
| Body | Mild steel, with insulated stirring and heating units |
| Capacity | 1 litre or 5 litres |
| Fittings | Lamp, cord and plug |
| Power supply | AC, 50 Hz, single phase |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 7–10 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Experiments on the Stirrer Hot Plate
Chemistry and biochemistry students use it to dissolve salts when making buffers and to keep a titration mixed while an electrode reads the change. In a pH titration, base runs in from a Burette, Borosilicate Glass, with PTFE Stopcock and each step is read on a Digital pH and mV Meter. Steady stirring gives a sharp, repeatable end point on the curve.
With the heater on, teachers can show how temperature changes solubility by warming a saturated potassium nitrate solution and watching more solid dissolve. A Round Magnetic Stirring Bar suits flat-bottomed beakers, and the Dumb Bell Magnetic Stirring Bar is made for viscous mixtures and round-bottom containers.
Frequently Asked Questions
Why does the stirring bar jump or spin out of the vortex?
The bar decouples when the speed is raised too fast or set too high for the liquid. The magnet below can no longer drag it round, so it rattles. Turn the regulator down, let the bar settle in the centre and raise the speed slowly.
Which stirring bar should I use?
Pick a bar a little shorter than the inside base of the vessel. A round bar with a pivot ring turns steadily in flat-bottomed beakers and flasks. A dumb-bell bar handles thicker mixtures and round-bottom vessels better.
How do the 1 litre and 5 litre models differ?
The figure is the most liquid each model is made to stir. The 1 litre model suits the beakers and flasks used in student practicals. The 5 litre model takes bigger batches, such as media or buffer stocks for a whole class.
Can I heat any glass vessel on it?
Use flat-bottomed borosilicate glass, so the base sits fully on the plate and heats evenly. Round-bottom flasks wobble and heat unevenly on a flat plate. Never heat a sealed vessel, and keep flammable solvents away from a hot plate.
Should I start the stirrer or the heater first?
Start stirring first at a low speed, then switch on the heating. Moving liquid spreads the heat and stops the bottom layer from overheating or bumping. Switch the heating off before you lift the vessel away.
Other Magnetic and Overhead Stirrers
- Magnetic Stirrer Cum Hot Plate (stainless steel top plate)
- Hotplate & Magnetic Stirrer
- Magnetic Stirrer
- Laboratory Stirrer (overhead shaft and blades)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
