CNC Lathe Machine with Cabinet and PC Manufacturer,Supplier and Exporter in India
Product Code : EL-CTM-9076
Jlab Export is a leading CNC Lathe Machine with Cabinet and PC Manufacturer,and suppliers in India
Supplied with a cabinet and a PC, this CNC lathe is a compact two-axis machine for teaching programmed turning. It takes work up to 360 mm between centres and swings 100 mm over the bed and 60 mm over the apron. The spindle runs from 100 to 2250 rpm on a 600 W motor. A 4-position tool post indexes through 360°.
Specifications
| Distance between centres | Up to 360 mm |
| Swing over bed / over apron | 100 mm / 60 mm |
| Bed width | 100 mm |
| Travel (X / Z) | 150 mm / 250 mm |
| Spindle | 100–2250 rpm, 600 W main motor |
| Slide speeds (X, Z) | Rapid up to 2000 mm/min, feed up to 500 mm/min |
| Axis motors (X, Z) | 1.35 Nm each |
| Positioning accuracy / repeatability | 0.015 mm / 0.01 mm |
| Tool post | 4 positions, 360° indexing, return orientation precision 0.005 mm |
| Tailstock travel | 50 mm |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Workshop Exercises on the CNC Lathe
Students begin by facing and turning a stepped pin from aluminium or brass bar. The program uses G00 for rapid moves, G01 for cuts along Z and across X, and G02 or G03 for a radius on a shoulder. Each tool is touched off to record its offset, and the work zero is set on the faced end. A dry run with the tool clear of the bar comes before the first cut.
Diameters are then checked with an External Micrometer and step lengths with a Vernier Caliper. A Dial Gauge held against the turned diameter shows run-out as the spindle is turned slowly by hand. Teachers can change the programmed feed and speed between two parts so the class can compare the finish.
Frequently Asked Questions
Why are there two swing figures?
Swing over the bed, 100 mm here, is the biggest diameter that clears the bed ways. Swing over the apron, 60 mm, is the biggest diameter that clears the carriage, so it limits work turned along its length. Plan bar sizes from the smaller figure.
How do the 2000 mm/min and 500 mm/min speeds differ?
2000 mm/min is the fastest the X and Z slides move, used for G00 rapid moves between cuts. 500 mm/min is the top feed speed for cutting moves. The actual feed is set in the program to suit the material and the tool.
How many tools can be set up at once?
The tool post holds 4 tools and indexes through 360°, returning each position to within 0.005 mm. A class can load a turning tool, a facing tool and a parting tool and keep one position spare, each with its own offset.
How are tool offsets set on a CNC lathe?
Each tool in turn is brought up to the end face of the bar for Z and to a measured turned diameter for X. The control stores the X and Z distances as that tool’s offset, so one work zero serves every tool. A test cut and a second measurement then correct any small error.
Other CNC Lathes and Lathe Trainers
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
