• +91-85699-09696

CNC Trainer Lathe Machine Manufacturer,Supplier and Exporter in India

CNC Trainer Lathe Machine

Product Code : EL-CTM-9023
Jlab Export is a leading CNC Trainer Lathe Machine Manufacturer,and suppliers in India

Built on LM guideways with 15 m/min rapids on both axes, this trainer lathe is a compact turning machine for short parts. It turns up to 55 mm diameter and 100 mm long and takes bar up to 12 mm through the spindle. A two-station linear turret carries 16 x 16 mm tools.

Specifications

Turning diameter (standard / max.)50 / 55 mm
Max. turning length100 mm
Swing over bed150 mm
Spindle1.5 HP motor, up to 4000 rpm, 35 mm bore
Bar capacity / chuck size12 mm / 80 mm
TurretLinear, 2 stations, 16 x 16 mm tools, boring bar up to 32 mm
Strokes (X / Z)150 / 100 mm
Rapid traverse and guideways15 m/min on X and Z, LM guideways
Position accuracy / repeatability0.015 mm / ±0.003 mm
Machine size (L x B x H)1250 x 850 x 1650 mm, approx. 1000 kg
Minimum order quantity1 unit
Dispatch timeUsually 14–18 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Practicals on the Trainer Lathe

Short parts suit this machine, so classes often turn a batch of small pins or bushes. Students write the program with G01 cuts and G02 or G03 arcs, simulate it, then run the first part slowly before the batch runs at full rapid. A linear turret holds the tools side by side on the cross slide, and the program picks a tool by moving the slide to it.

With only two stations, students learn to plan a job around one turning tool and one boring or grooving tool. The Dial Gauge shows run-out of the work in the 80 mm chuck before cutting starts. Outside diameters across the batch are then checked with the External Micrometer, and the class can plot how the size drifts as the tool wears.

Frequently Asked Questions

What are the standard and maximum turning diameters?
The standard turning diameter is 50 mm and the maximum is 55 mm, over a 150 mm swing. The swing gives clearance for the chuck and tools, while the turning figures give the part sizes the trainer is meant to cut.

What is the bar capacity?
Bar up to 12 mm can be fed through the spindle, which has a 35 mm bore. Larger stock is cut into blanks and held in the 80 mm chuck instead.

Why does this trainer use LM guideways?
LM guideways are linear motion rails with rolling elements under the slides. They have low friction, which suits fast, short moves such as the 15 m/min rapid traverse used on both axes.

Which accuracy figure matters most for batch work?
Repeatability, plus or minus 0.003 mm, matters most. With the offsets set from a measured part, the slides return to the same place and a run of short parts stays close to one size. The 0.015 mm position accuracy is the error allowed at a programmed point.

Other Turning Trainers

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 6 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us