Cutting Disk Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-13050
Jlab Export is a leading Cutting Disk Manufacturer,and suppliers in India
An abrasive cutting disc turns an angle grinder into a cut-off tool for steel bar, angle, tube and sheet. It cuts on its edge only, leaving a narrow slot through the work. This disc is for metal, fits a 125 mm grinder and comes in two thicknesses, 3 mm and 5 mm.
Specifications
| For use on | Metal |
| Diameter | 125 mm |
| Thickness | 3 mm or 5 mm |
| Minimum order quantity | 50 units |
| Dispatch time | Usually 3–5 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Cutting Practicals in the Fitting Shop
For a frame-making exercise, students mark lengths of Angle Iron with a square and scriber and clamp each piece. They cut on the line with the disc fitted to a Portable Angle Grinder. The offcut is left free to drop away, so the slot opens rather than closing on the disc.
The cut ends are then dressed with the Grinding Disk to take off the burr. Students can also cut the same section by hand with Hack Saw Blades. They then compare the time taken, the width of the cut and the heat left in the part.
Frequently Asked Questions
Can I grind with the side of a cutting disc?
No. A cutting disc is made to work on its edge only, and side pressure can crack it at speed. For weld beads or bevelled edges, change to a grinding disc before you start.
Should I use the 3 mm or the 5 mm disc?
The 3 mm disc takes a narrower slot, so it cuts faster and puts less heat into the part. The 5 mm disc is stiffer, which helps on heavy sections and long cuts.
Why does the disc jam in the cut?
It jams when the slot closes on it, usually because the work sags toward the cut or the grinder is twisted. Clamp the work, let the offcut fall away and keep the disc in line with the cut.
Can it be used to cut copper refrigeration pipe?
It is better not to. An abrasive disc leaves burrs and grit inside the pipe, and these can end up in the refrigerant circuit. Copper pipe is cut with a Tube Cutter and then reamed.
What protective gear is needed?
Wear goggles or a face shield, gloves and close-fitting clothes, and keep the guard on the grinder. Sparks travel a long way, so clear the area of anything that can catch fire.
Other Metal Stock and Shop Supplies
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
