Tee Fitting Manufacturer,Supplier and Exporter in India
Product Code : EL-MWLE-13040
Jlab Export is a leading Tee Fitting Manufacturer,and suppliers in India
Made of brass with male ends, this tee makes a three-way branch in a line built with threaded connections, so the joint can be undone later for service. It comes in 1/4, 5/16, 3/8, 1/2 and 9/16 inch sizes. Gauge points, service branches and test circuits on a training bench are typical uses.
Specifications
| Material | Brass |
| Ends | Male |
| Sizes | ¼, 5/16, 3/8, ½ and 9/16 inch |
| Minimum order quantity | 100 units |
| Dispatch time | Usually 3–5 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Flaring Practicals with a Brass Tee
In refrigeration work, male brass fittings like this are joined to flared copper tube with flare nuts. Students cut the tube with a Tube Cutter and clean the end with the inner-outer reamer from a Hydraulic Flaring And Swaging Tool Kit. They slip the flare nut on, then form the flare with the same kit.
Each nut is tightened with two spanners, one holding the tee body so the branch does not twist. The assembly is pressurised with a Nitrogen Pressure Test Kit, and every flare is checked with Bubble Solution For Leak Detection. Teachers can then braze the same branch with the copper Tee Fitting, so students see both joint types side by side.
Frequently Asked Questions
How do I tighten a flare nut on the tee without twisting it?
Hold the tee body with one spanner and turn the nut with another, so the tee and the other lines stay still. Tighten firmly but stop there, because too much force thins or splits the flare.
Should thread tape go on the male threads?
No. A flare joint seals on the flared tube face, not on the threads, so tape does nothing for the seal and loose shreds can enter the system. A drop of refrigeration oil on the flare face helps it seat.
Which size tee do I need?
Choose the inch size that matches the tube and flare nuts in the line: 1/4, 5/16, 3/8, 1/2 or 9/16 inch. Measure the outside diameter of the tube before ordering.
Should I pick this brass tee or the copper tee?
Pick the brass tee where a joint must come apart for service or where brazing is not possible on site. Pick the copper tee for permanent brazed joints, which leave fewer places for a leak to start.
Other Brass Flare Fittings and Tools
- Union (brass, male ends)
- Flare Fitting Set
- Flare To Solder Fitting
- Eccentric Flaring Tool (flares inch-size tube)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 5 November 2026
