• +91-85699-09696

Oil Bath (High Temp) with Stirrer Manufacturer,Supplier and Exporter in India

Oil Bath (High Temp) with Stirrer

Product Code : EL-B-1962
Jlab Export is a leading Oil Bath (High Temp) with Stirrer Manufacturer,and suppliers in India

An oil bath takes over when a flask must be held hotter than a water bath can reach, since water boils away at normal pressure. This one heats its oil from 50 °C to 250 °C under thermostat control, to ±2 °C. A stirrer keeps the oil at one temperature throughout. The double-walled chamber of polished stainless steel or copper comes with diffuser shelves and a cover.

Specifications

ConstructionDouble wall
Inner chamberHighly polished stainless steel or copper sheet
Outer bodyMild steel, stoving enamel finish
Temperature range50 °C to 250 °C, ±2 °C
ControlThermostat with control knob
PanelOn-off switch and pilot lamps
Supplied withStirrer, diffuser shelves and cover
Chamber sizes250 x 250 x 250 mm (10 x 10 x 10 in), 300 x 300 x 250 mm (12 x 12 x 10 in), 350 x 350 x 250 mm (14 x 14 x 10 in)
Minimum order quantity1 unit
Dispatch timeUsually 7–10 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Organic Chemistry Practicals

In organic chemistry, students heat a reaction mixture under reflux in a Flasks, Round Bottom, Short Neck JLab topped with a Condensers, Liebig. The flask sits in the stirred oil with its contents below the oil level, which heats it evenly and without the hot spots of a flame. Ester and amide preparations with high-boiling mixtures are typical runs.

The bath also serves for distilling liquids that boil above the range of a water bath, with the distilling flask lowered into the oil. Teachers can compare how quickly a flask comes to temperature in stirred oil and over a burner, and point out how much steadier the oil-heated run is.

Frequently Asked Questions

What oil should I fill it with?
Use an oil sold for laboratory heating baths and rated above the highest temperature you will set. Change it when it turns dark or thick, because old oil heats unevenly and leaves a film on glassware.

Why does an oil bath need a stirrer?
Oil is thick and carries heat slowly. Without stirring, the oil near the heater runs much hotter than the oil at the top. The stirrer keeps the whole bath close to the thermostat setting, within ±2 °C.

What are the diffuser shelves for?
They give a flat support inside the chamber and spread the heat rising from below. A flask or beaker stands on them instead of sitting right over the heater.

How do I keep water out of the oil?
Dry the outside of each flask before lowering it in, and keep the cover on when the bath is idle. Drops of water in hot oil turn to steam and make the oil spit.

Which chamber size suits my work?
The 250 mm cube takes a single round-bottom flask. The 300 and 350 mm chambers take larger flasks or several small vessels. All three are 250 mm deep, so a flask can sit well down in the oil.

Other Heated Baths

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 12 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us