• +91-85699-09696

Paraffin Section Flotation Bath Manufacturer,Supplier and Exporter in India

Paraffin Section Flotation Bath

Product Code : EL-B-1960
Jlab Export is a leading Paraffin Section Flotation Bath Manufacturer,and suppliers in India

This is a section flotation bath for histology and pathology, not a pot for melting wax. It holds 2.5 litres of hot distilled water at a set temperature between 30 °C and 70 °C, steady to ±0.5 °C. Paraffin ribbons are floated out on it and picked up on slides. Its black PTFE-coated interior makes pale sections easy to see.

Specifications

TypeParaffin section flotation bath
Capacity2.5 litres
Temperature30 °C to 70 °C, set by the user
Temperature stability±0.5 °C
Control typeSet-point temperature control, not power-only
BathAluminium base with black PTFE-coated interior
ExteriorPowder-coated aluminium
Heat-upStable 45 °C with 2.25 litres of water in 40 minutes
Heater power240 W
Dimensions (d x w x h)330 x 330 x 140 mm
Weight2.7 kg
Minimum order quantity1 unit
Dispatch timeUsually 7–10 working days
ManufacturerJLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India

Histology Practicals with the Flotation Bath

Students cut ribbons from wax blocks on a Rotary Microtome and float them on the bath, set a little below the melting point of their wax. Against the black lining they can pick out folds, knife lines and holes, and choose a clean section to mount. Dried slides then pass through Staining Jars for dewaxing and staining.

A useful class exercise is to float sections from one ribbon at two settings and compare how fast and how far they spread. The blocks themselves are made earlier in a Paraffin Embedding Bath, which holds molten wax and is a different instrument from this water bath.

Frequently Asked Questions

How long does the bath take to warm up?
With 2.25 litres of water it reaches a stable 45 °C in about 40 minutes. Switch it on at the start of the session, before you trim the blocks, so it is ready when the first ribbon is cut.

Why is the inside black?
Thin paraffin sections are pale and hard to see against a light surface. The black PTFE lining makes them stand out, so you can check each one for creases or holes before lifting it. Wax also wipes off the PTFE surface easily.

Is this bath used to melt paraffin wax?
No. It holds warm water for floating cut sections. Wax is melted and held for embedding in a wax or embedding bath, which contains molten wax instead of water.

Why set a temperature rather than heater power?
With a set point, the controller holds the water at the value you choose, within ±0.5 °C. A power-only control lets the water creep upward over a long session, and water that gets too warm softens the wax and spoils the sections.

How much bench space does it need?
The bath measures 330 x 330 x 140 mm and weighs 2.7 kg, so it sits beside the microtome on an ordinary bench. Its heater is rated at 240 W.

Other Section and Wax Equipment

For a quote, use Add To Cart or send us a message through the contact page.

Last updated: 20 November 2026


   

Office Address

Works: 2475-84,
Hargolal Road,Ambala, Haryana

[email protected]

+91-85699-09696

Follow Us