Screwdriver Manufacturer,Supplier and Exporter in India
Product Code : EL-WT-12953
Jlab Export is a leading Screwdriver Manufacturer,and suppliers in India
Electrical terminals, switch plates and slotted screws in panels are the everyday work for this flat-tip driver. It is fully insulated and magnetic, with an anti-slip grip. It comes in six sizes, from #0 x 75 mm up to 4 x 100 mm, so the blade can be matched to the slot.
Specifications
| Tip type | Flat (slotted) |
| Features | Magnetic, fully insulated |
| Grip | Anti-slip |
| Sizes | #0 x 75 mm, #1 x 75 mm, #2 x 100 mm, 2.5 x 75 mm, 3 x 100 mm, 4 x 100 mm |
| Minimum order quantity | 10 units |
| Dispatch time | Usually 4–6 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Wiring Practicals for Electrician Trainees
In a wiring practical, trainees strip conductor ends with the Wire Stripper and loop them with the Combination Plier. They clamp the ends under the terminal screws of switches, sockets and a distribution board. The magnetic tip holds steel fixing screws, such as those of a switch plate, while they are started.
Before touching any terminal, they switch off the supply and check it with the Neon Tester. The insulation on the driver does not replace switching off. Teachers can also show how a blade that is too narrow or too thin twists out of the slot and damages the screw head.
Frequently Asked Questions
How do I pick the right blade size?
Choose the widest blade that fits the slot without overhanging the screw head, and one thick enough to fill the slot. A blade that is too small twists out and chews the slot. The six sizes run from #0 x 75 mm to 4 x 100 mm, and the second figure is the blade length.
What does the magnetic tip do?
It holds a steel screw on the blade, so the screw can be started in a box or a hole that fingers cannot reach. It also lifts a dropped steel screw back out of a switch box or a panel. Brass terminal screws are not magnetic and must be held by hand.
How should the screwdriver be looked after?
Keep the insulation free of cuts and cracks, and stop using a driver whose insulation is damaged. Do not use it as a lever, chisel or punch, since that bends the blade and splits the handle. Wipe off grease so the anti-slip grip stays firm in the hand.
How is it different from the angled flat screwdriver?
The angled flat Screwdriver in this range is a single 2 x 75 mm size in chrome vanadium steel, for screws in tight places. This one is straight, insulated and magnetic, and comes in six sizes for general electrical work.
Other Screwdrivers in This Range
- Screwdriver (angled flat tip, 2 x 75 mm)
- Screwdriver (magnetic cross-head, seven sizes)
- Screwdriver (angled cross-head, 2.5 x 100 mm)
- Screwdrivers (set of four in chrome vanadium steel)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
