CNC Lathe System Manufacturer,Supplier and Exporter in India
Product Code : EL-CTM-9074
Jlab Export is a leading CNC Lathe System Manufacturer,and suppliers in India
With 600 mm between centres and a 260 mm swing over the bed, this CNC lathe system takes the shafts and flanges used in workshop training. The spindle runs from 30 to 4000 rpm through a 26 mm bore. It cuts metric threads from 0.2 to 3.5 mm pitch and inch threads from 8 to 56 TPI, driven by a 2.2 kW motor.
Specifications
| Distance between centres | 600 mm |
| Swing over bed | 260 mm |
| Spindle bore | 26 mm |
| Spindle speed | 30–4000 rpm |
| Thread pitches | Metric 0.2–3.5 mm, inch 8–56 TPI |
| Axis travel (X / Z) | 130 mm / 465 mm |
| Rapid traverse (X / Z) | 3000 / 2500 mm/min |
| Positioning accuracy (X / Z) | 0.03 / 0.032 mm |
| Repeatability (X / Z) | 0.012 / 0.013 mm |
| Motor | 2.2 kW, 230 V, 50 Hz |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Turning and Threading Practicals
Long work is held between centres for a first shaft. Students program the turned diameters with G00 and G01 and a chamfer or radius with G02 or G03. They then set the X and Z tool offsets by touching off. The program runs in simulation first, and the first cut is watched with the rapid rate turned down.
Threading is where this machine shows its range. Students can cut a metric thread on one shaft and an inch thread on the next, using a threading cycle. The finished thread is checked with a Thread Gauge, diameters with an External Micrometer and lengths with a Dial Caliper. Cutting the same pair of threads on a conventional Center Lathe Machine shows students the gear and lever settings that the CNC program replaces.
Frequently Asked Questions
Which thread pitches can it cut?
It cuts metric threads from 0.2 to 3.5 mm pitch and inch threads from 8 to 56 threads per inch. The pitch is set in the program, so moving from one thread to another needs no change gears.
Why is a thread cut in several passes?
A full thread form is too much metal to remove in one cut. The threading cycle takes a series of passes, each a little deeper and lighter than the one before. The control starts every pass at the same point of the spindle turn, so the tool follows the same groove. A final spring pass at full depth cleans the flanks.
What do the positioning and repeatability figures tell us?
Positioning accuracy, 0.03 mm in X and 0.032 mm in Z, is the maximum error when an axis moves to a commanded point. Repeatability, 0.012 mm in X and 0.013 mm in Z, is the spread when it returns to the same point again and again.
What motor and rapid rates does it have?
The lathe has a 2.2 kW motor rated for a 230 V, 50 Hz supply. Rapid traverse is 3000 mm/min in X and 2500 mm/min in Z, with 130 mm and 465 mm of travel.
How much space does the packed machine take?
The packing size is 2220 x 820 x 1720 mm. Doorways and the route to the workshop should be checked against these sizes before the lathe arrives.
Other CNC Lathes
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 6 November 2026
