CNC Training Mill Manufacturer,Supplier and Exporter in India
Product Code : EL-CTM-9037
Jlab Export is a leading CNC Training Mill Manufacturer,and suppliers in India
This CNC training mill is a three-axis machine with travels of 300 mm on X, 225 mm on Y and 350 mm on Z. Its spindle speed reaches 4000 rpm and the axes rapid at 10 m/min. The CNC system with axis motors and drives, coolant, lubrication and a chip collector are part of the standard supply.
Specifications
| Travels (X / Y / Z) | 300 / 225 / 350 mm |
| Rapid | 10 m/min |
| Spindle speed | 4000 rpm |
| Supplied with | CNC system with axis motors and drives, spindle with induction or servo motor |
| Also standard | Chip collector with chip bin, coolant system, lubrication system |
| Tooling options | Automatic tool changer, tooling system with tools, special tooling, job holding fixtures or pallets |
| Software options | CAD/CAM software, simulation software licences for several users |
| Shop options | Chip conveyor, voltage stabiliser, air compressor, coolant through spindle, panel air conditioner |
| Minimum order quantity | 1 unit |
| Dispatch time | Usually 14–18 working days |
| Manufacturer | JLab (Jain Laboratory Instruments Pvt Ltd), Ambala, India |
Milling Practicals on the Training Mill
A good first project is a plate with a pocket, a slot and a ring of bolt holes. Students draw it, produce the G-code in CAD/CAM software or write it by hand, and run it in simulation before it reaches the machine. On the mill they set the work offset from the plate edges and give each cutter a length offset.
The 350 mm Z travel leaves room for a vice and long tools in one setup, so drilling and milling can share it. Pocket depths are read with the depth rod of a Dial Caliper, and the slot width with its inside jaws. Where the automatic tool changer option is fitted, teachers can compare cycle times with the CNC Trainer Milling Machine, which changes tools by hand.
Frequently Asked Questions
What does the automatic tool changer option add?
Without it, cutters are changed by hand at each tool call. With it, the program calls each tool and the machine swaps it, so a part that needs several tools runs without stopping, as on a production machining centre.
Why does the cutter chatter on deep pocket walls?
Chatter comes from a set-up that springs. A cutter sticking well out of its holder, a wide step-over at full depth, a worn cutter or loose clamping all let it vibrate. Use the shortest tool that reaches, cut the depth in stages and try a slightly different spindle speed. A light finishing pass then cleans the wall.
What does coolant through spindle add?
Coolant through spindle is an option. It sends coolant down the spindle and out through holes in drills and cutters made for it. This clears chips from deep holes and keeps the cutter cool.
How fast does it move between cuts?
The rapid rate is 10 m/min. During rapid moves, programmed with G00, the cutter must stay clear of the work and clamps, which is why every new program is checked in simulation first.
Other CNC Milling Trainers
- CNC Trainer Milling Machine
- CNC Milling Trainer Deluxe
- CNC Mill Trainer
- CNC Training Lathe (turning trainer with the same option list)
For a quote, use Add To Cart or send us a message through the contact page.
Last updated: 20 November 2026
